Titan Tool 2000XD Manuel d'utilisateur télécharger pdf (Page 10)

BASIC! OPERATION!(c o nt i n u e d )

To increase the level of discrimination, press the DISCRIMINATION ▲

touch pad. Each time the ▲ pad is depressed, an additional "R" will appear,

thus eliminating from detection the objects which fall into the

corresponding categories.

To decrease the level of discrimination, press the DISCRIMINATION ▼

touch pad. Each time the ▼ pad is depressed, an illuminated "R" will

disappear, thus returning to detection the objects which fall into the

corresponding categories.

Discrimination Mode is a fixed-start-point elimination system. Objects are

cumulatively eliminated as the level of discrimination increases.

NOTCH MODE

To selectively eliminate a category from detection within the metallic

spectrum, use the NOTCH Mode.

Technical Note:

The NOTCH touch pad causes the status of an "R" segment to toggle

between ON and OFF.

To use the NOTCH Mode:

The NOTCH touch pad can be depressed at any time. But for

first-time use, place the detector in ALL-METAL mode.

A first demonstration is best accomplished as follows:

1) Turn the power OFF.

2) Turn the power ON.

3) Press NOTCH.

A flashing "R" will appear under the IRON segment.

4) Press the DISCRIMINATION ▲ touch pad several times

Notice that the "R" moves upon each press of the

DISCRIMINATION ▲ touch pad.

5) Press NOTCH again.

The flashing "R" will become permanently illuminated.

If an object has been “notched-out”, you can return it to detection

status. To “un-notch” a category:

1) Press NOTCH.

2) Move the flashing “R” over the permanently illuminated “R”.

3) Press NOTCH again.

Titan2000MANUAL.qx6 4/22/08 12:29 PM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Titan Tool 2000XD Manuel d'utilisateur Page 10